The Host requires you to activate the ReWire engine before launching the ReWire Device application.

At this point, launching Live next should start it as ReWire Device. Once the application has started, you can close it again and launch the ReWire Host. Launching Live as standalone is required also each time you switch between different Live versions (between 32-bit and 64-bit, or between Live 8 and Live 9 for example). This is necessary to install its own ReWire engine.

Live has not yet run as standalone once.

ReWire Host and ReWire Device are not running at the same bit depth. ReWire will only work if both applications are in 32-bit or 64-bit mode.

This could be happening for one of the following reasons: If it doesn't work, please check the manual for the ReWire Device application. In Live, no action needs to be taken to enable ReWire: just launch Live and then the audio application you wish to use as ReWire Device should automatically ReWire itself to Live. The ReWire Device application fails to start as ReWire Device

Loud 'buzz' when running Live as rewire Device to Logic or Digital Performer.Live doesn't work as ReWire Device with Digital Performer.No sound from Reason when running it as ReWire Device to Live.Live can't be ReWired to Hosts when they use DAE.Live does not work as ReWire Device with Logic 7.Live does not appear as ReWire Device in Pro Tools.Error Message - 'The installed ReWire version is too old for this implementation.' (Mac).Error Message - 'Detected problems with ReWire Host application.Error Message: 'An Error has occurred while opening the ReWire system' (Mac).Error Message: 'Live has detected another active ReWire Host Application.'.Please quit both the current ReWire Host application and Live, and then launch Live once as a standalone application so that it can install its ReWire engine.' Error Message: 'The ReWire Host Application has detected a different version of Live than the last one used.Live quits after 30 minutes when using ReWire.The ReWire Device application fails to start as ReWire Device.

While ReWire may still be visible in Live 10 and earlier, we cannot guarantee that it will work as normal since the technology is no longer updated. Support for ReWire was ended by the developer in 2020 and ReWire is not available in Live 11.

Does waves v9 work on pro tools 12